Warranty
Should any parts of the boiling water unit fail within;
1 year of installation, that the part will be replaced or repaired by the manufacturer or its authorised service agent free of charge as per warranty conditions 1 to 6 and warranty exclusions 1 to 4.
Wiffen Products Pty Ltd hereby warrants that in addition to the protection given to Australian consumers under the Trade Practices Act, any other similar Act or Law, we will if necessary replace or repair on the terms and conditions set out hereunder any boiling water unit manufactured by this company.
Warranty Conditions
- The boiling water unit must be installed to comply with all relevant statutory and local requirements for the area where the boiling water unit is installed.
- The boiling water unit must be installed in accordance with manufacturers installation instructions supplied with the unit.
- When a boiling unit is repaired or replaced under this warranty, the component or boiling unit replaced does not have the benefit of a new warranty and only the balance of the original warranty period will remain effective.
- Only the boiling water unit and genuine company replacement parts are covered by this warranty. Electrical or plumbing parts supplied by the installer are not covered by this warranty.
- The cost of insurance, traveling and transport between the installed site and the nearest manufacturers authorized agents premises will be to the account of the customer where unit is installed outside the boundaries of the metropolitan area as defined by the manufacturer or beyond 25km from a manufacturers or an authorized agent in a regional town or centre.
- A water filter that is specified by a manufacturer and/or supplied as original equipment with the boiling water unit, must be fitted on the cold water supply to the boiling water unit, and maintained by the owner in a serviceable and working condition, while the boiling unit is in service. Failure to fit and maintain the filter will render this warranty void.
Guarantee period - Twelve (12) months from the date of sale by Wiffen Products Pty Ltd.
Warranty Exclusions
The warranty may become void by the following exclusions and service charge for the labour and parts (if necessary) could become a cost to the owner.
- Failure due to misuse and/or incorrect installation; Acts of God; Water conditions; Accidental damage; Unauthorised attempts at repair of the boiling water unit.
- Where there is a failure of the electricity or water supply; where water leaks are caused by the plumbing and not the boiling water unit or its components; where there is no flow or hot water due to faulty plumbing or filter blockage; where the complaint is related to high or low water pressure or excessive water pressure; where it is found that there is nothing wrong with the boiling water unit.
- Repairs to a boiling water unit due to scale formation or where the boiling water unit has been fitted to a hard or harmful water supply or the recommended or supplied filter has not been fitted and maintained.
- Where the boiling water unit has been installed in a position that does not comply with the manufacturers installation instructions or relevant statutory requirements or subject to any statutory provisions to the contrary claims to damage to walls, furniture, carpets, foundations or the need for major dismantling or removal of cupboards, doors or walls or any other consequential loss either directly or indirectly due to leakage from a boiling water unit.
Chiller units have a twelve (12) month warranty on parts and labour from date of sale.
Chiller units have the same warranty exclusions as boiling water units.
Australian Service Agents
New South Wales
Boiling Billy
Click to view full detailsContact: Tania Wiffen
Phone: +61 (0) 3 5248 7072
Fax: +61 (0) 3 5248 7272
Email: This email address is being protected from spambots. You need JavaScript enabled to view it.
1/33 Cedar Parade, Moolap, VIC, 3224
Northern Teritory
Boiling Billy
Contact: Tania Wiffen
Email: This email address is being protected from spambots. You need JavaScript enabled to view it.
1/33 Cedar Parade, Moolap, VIC, 3224
Queensland
Mark Anderson Sales
Building 4, 84 Ingleston Rd, Wakerley, QLD, 4154
South Australia
Boiling Billy
Click to view full detailsContact: Tania Wiffen
Email: This email address is being protected from spambots. You need JavaScript enabled to view it.
1/33 Cedar Parade, Moolap, VIC, 3224
Tasmania
Boiling Billy
Contact: Tania Wiffen
Email: This email address is being protected from spambots. You need JavaScript enabled to view it.
1/33 Cedar Parade, Moolap, VIC, 3224
Victoria
Interchange Sales And Marketing
Contact: Kevin Cottom
Unit 4, 49 Corporate Blvd, Bayswater, VIC, 3153
Western Australia
Pride Industries
23 Munt Street
Bayswater WA 6053
Ph: 08 9272-6511 Fax: 08 9272-3427
Email: This email address is being protected from spambots. You need JavaScript enabled to view it.
Complete Enviro Solutions
Contact: Ken